KitchenAid Wall Oven FCE1 / FCE2 / FCE3 Error Code

A Wi-Fi code

FCE1, FCE2 and FCE3 on a Wi-Fi-equipped KitchenAid oven concern the wireless link, not heating. KitchenAid’s wording is that the appliance failed to reach the router.

Possible sources

• the connection timing out
• a weak signal
• the router going bad
• the oven’s own Wi-Fi module
• wiring

You can check signal strength and the router at home, so begin with those.

Working through it

1. Cycle the oven’s breaker with a minute off, watch for a minute after restoring it, and check the oven operates.
2. Restart your wireless router.
3. Test another Wi-Fi device; the article recommends bringing a phone or tablet to the spot where the oven is installed.
4. When that device is fine: router unplugged for 2 minutes then plugged in, followed by the oven’s power disconnected for 2 minutes then reconnected.

Signal not strong

If the bars are not full, the article gives three options. Move the router to another place in the house, add an extender that is compatible, or get in touch with your internet provider.

Calling for a technician

After the router and the oven have both been reset, a persisting code leaves only the Wi-Fi module and the wiring on the list, and those are for a technician.

Other connectivity codes

• FCE7: the oven failed to join your router
• FCE4 and FCE5: antenna trouble
• FCE6 and FCE9: the power module for Wi-Fi

Connected oven repair in Los Angeles

If an FCE code outlasts both resets, ring (310) 363-8964. Give the code you see, the model number and a note that the router was reset.

Source: KitchenAid Product Help, Wall Oven: Error Code or Message