For the KitchenAid refrigerator record covered here, E1 is associated with compressor current/amperage problem. This wording should be read narrowly: it describes the system or condition the control is reporting, not a guaranteed failed part.
Reviewed by Liam Porter · Last reviewed August 11, 2026
Written by
Liam Porter Appliance Care EditorPublished September 2, 2026
Content status:
Verified
Error codeE1
ApplianceRefrigerator
Affected model seriesKitchenAid built-in, Professional, 5 Series and 7 Series refrigeration (confirm your model manual)
Quick answer
For the KitchenAid refrigerator record covered here, E1 is associated with compressor current/amperage problem. This wording should be read narrowly: it describes the system or condition the control is reporting, not…
Model compatibility: KitchenAid reuses codes across series and model years, so E1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
Compressor fault (E1) — high or low compressor amperage detected by the control.
Signs
Symptoms you may notice
Cooling may become weak or stop.
The compressor may cycle abnormally or fail to stay running.
Temperature alarms may appear if the condition persists.
Why it happens
Possible causes
Abnormal compressor current draw.
Supply, start/control, or wiring problems affecting the compressor.
A compressor or sealed-system condition requiring professional diagnosis.
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Disconnect power at the breaker for five minutes, then restore to clear stored alarms. Press alarm/controls per your manual if applicable.
Do not attempt compressor repair — sealed system and line voltage
Book independent KitchenAid service
Important safety warning. Never open the sealed refrigerant system. Condenser fan and compressor work involves high voltage.
Please avoid
What not to attempt
Do not open internal panels or access high-voltage components
Do not bypass door locks, safety switches or interlocks
Get help
When to call a technician
If the safe checks do not resolve the condition, schedule an independent KitchenAid appliance diagnosis. Provide the full model number and a photo of the E1 display so the technician can start with the correct model-specific code map.
Seeing this code on your KitchenAid appliance?
Book a specialist visit for a clear estimate and approval before any repair. Independent service — not an official KitchenAid service center.
For the KitchenAid refrigerator record covered here, E2 is associated with condenser fan motor amperage out of range. This wording should be read narrowly: it describes the system or condition the control is reporting…
For the KitchenAid refrigerator record covered here, E3 is associated with evaporator thermistor problem. This wording should be read narrowly: it describes the system or condition the control is reporting, not a guar…
For the KitchenAid refrigerator record covered here, E4 is associated with display/control thermistor problem. This wording should be read narrowly: it describes the system or condition the control is reporting, not a…
For the record covered by this page, E1 relates to compressor current/amperage problem. Confirm the exact definition against the full model number before ordering parts or authorizing an internal repair.
You can correct an obvious external condition and use the normal owner-approved restart or acknowledgement procedure. If the same code returns, clearing the display again does not repair the cause.
Only if the condition is clearly a normal status/maintenance indication and the appliance is operating normally. Stop using it for smoke, burning odor, arcing, repeated breaker trips, uncontrolled heating, gas odor, active leakage near electrical parts, or a significant loss of refrigeration.
No. The code identifies a condition or diagnostic path. Model-specific testing should confirm the failed component before parts are ordered.
